مرجـع دانـش پارس

نوع فایل:PDF

تعداد صفحات :8

سال انتشار : 1395

چکیده

In this paper, a study is presented on the experimental and numerical analysis of the failureprocess in 5, 10 and 15mm thicknesses of Aluminum 5083 subjected to normal impact by flatnosedprojectiles that have been made of Tungsten. To modeling the behavior of materials,Johnson–Cook constitutive equation and fracture criterion are used. In all tests, initial andresidual velocities of the projectile are measured and the ballistic limit of each target plate isprecisely determined. Based on thesemeasurements, impact versus residual velocity curves ofthe plates are constructed and the ballistic limit velocity of each target is obtained. Finiteelement analysis of the problem is carried out using ABAQUS/Explicit finite element code.Results of the numerical analysis are compared with the experiments and good correlationbetween the two was found. It is shown that especially the results obtained by the finiteelement approach are encouraging in terms of predicting the response of the plates examined

واژگان کلیدی

Impact, Penetration, Ballistic Limit Velocity, Numerical Simulation, ABAQUS